Fuselage October 2006 Updates
October 4, 2006
High Pressure Fuel Pump.... - 1 hrs

Yesterday I got some of the stuff I ordered for the FWF from Vans. I also ordered the 90 degree AN fittings that were missing for the fuel valve. I installed test fit these in the valve and clecoed in position to the 704 bulkhead.

Next I installed the pump and filter to the base. This is ready to install to pipe in the fuel lines and fuel valve. For now I just clecoed the base with the pump in place to see where the fuel lines need to hook up. I will use the method Dan used to run these lines and hook up as I go.



This website was built to document my work in compliance with the FAA requirements needed to certify my aircraft.
My experiences and comments are by no means to be considered as instructions on how to build any aircraft.