Fuselage December 2007 Updates
December 02, 2007
Terminal Strip Panel.... - 2.0 hrs

Well Dru was in today so I got the bend done. I cut off the excess from the panel dropdown. I bent this to match the angle of the panel drop from the subpanel.

With this done I can mount the small strip to the angle at the bottom of the insturment panel. This should allow clearance for the camlocks up underneath. This is hard to describe. Once complete the pics will say a thousand words. HA!




This website was built to document my work in compliance with the FAA requirements needed to certify my aircraft.
My experiences and comments are by no means to be considered as instructions on how to build any aircraft.