Home Preparation Empennage Wings Fuselage Engine Finish Kit Favorite Links W & B Calculator Van's Aircraft Email Me

Finish Kit Update November 2010 Updates November 27, 2010 More Wing Tip Work ..... - 3.0 hrs Got to the hangar and started installing the Archer antenna. Removed the screws and match drilled the 3 holes in the wings. I ran the wires thru the clamps and screwed it in place. Next I started mixing up some epoxy to glue the strips I cut yesterday. These will back up the nutplates for the wingtip screws. As you can see I used a few clamps. While these were drying I messed with the wing root fairing again. I used some duck tape to hold the top in place while I crawled under the wing to cleco the bottom. You can see the vent line doubler sticking out from the fairing. Still looking on line for answers to this issue. This website was built to document my work in compliance with the FAA requirements needed to certify my aircraft. My experiences and comments are by no means to be considered as instructions on how to build any aircraft.