Finish Kit Update November 2010 Updates
November 13, 2010
Fuel tank sensor, fuel guardian, more wing bolts ..... - 4.0 hrs

Man this small stuff is taking forever. Hidden bolts, cotterpins, etc. Anyway I am down to 2 last wing bolts to install and one more that is installed to tighten up.

Anyway in between bolt breaks I pulled the fuel sensor wire back thru and installed some wire protector and then drilled a hole in the wing spar web to install a rubber grommet to pass it thru. Added a ring crimp and hooked it up.

Drilled a hole in the fuse to intall a snap bushing for the fuel guardian sensor wire. I will just run this up beside the pitot on the left and the AP servo wire on the right.





This website was built to document my work in compliance with the FAA requirements needed to certify my aircraft.
My experiences and comments are by no means to be considered as instructions on how to build any aircraft.