Finish Kit Update January 2012 Updates
January 29, 2012
More trimming and fitting the frame...... - 3.0 hrs

Pulled the canopy out in front of the hangar to warm it up a bit and trimmed more plastic back for another trim. Sealed off with electrical tape and then started on trimming.

First I used the multi tool to trim both sides and then used the die grinder with a 50 grit and course scotchbrite pad to clean up the edges.

Reinstalled on the plane to check for fit. Looks pretty good but need to warm up a bit for final drilling. Maybe next weekend I hope.

This website was built to document my work in compliance with the FAA requirements needed to certify my aircraft.
My experiences and comments are by no means to be considered as instructions on how to build any aircraft.