Home
Preparation
Empennage
Wings
Fuselage
Finish Kit
Favorite Links
W & B Calculator
Van's Aircraft
Email Me
|
|
Empennage October Updates
October 6, 2004
Prep of Rudder Frame and Skins
Took rudder apart and starting deburring. I used the counter sink tool to dimple the trailing edge wedge.
Continued work on deburring and dimpling of rudder internal structure. Primed everything except bottom and top ribs due to the tight dimple spots.
Completed dimpleing of tight areas of top and bottom ribs. Finished priming of top and bottom ribs. I Dimpled the left skin. Started riveting the stiffener plates to the rear rudder spar. Time to get this baby completed!
This website was built to document my work in compliance with the FAA requirements
needed to certify my aircraft. My experiences and comments are by no means to be
considered as instructions on how to build any aircraft.
|
| |